Loading... Please wait...
FREE SHIPPING ALL US ORDERS OVER $99

Our Newsletter

sign up today and save big on your next order

 

  • Image 1

Fuchs Full House 50 Head in Beige

$1,795.00
SKU:
FUCHS7P
Shipping:
Calculated at checkout
Quantity:

The Full House®-50 is a push pull Class-AB output stage using dual 6L6 power tubes for about 50 watts. The amp can accept EL-34's as well with a simple rebias. An excellent affordable amp that comfortable in your home practice room, for studio recording, and very much gig worthy! Through a single 12" cabinet or a dual 12" cabinet, the amp gets plenty loud! The amp features two channels. Channel one is a single volume control non-master channel with high, mid and low controls, a gain boost which works while keeping the tone controls active, and a digital reverb based on the same technology used in the Good Verbrations®® pedal. This provides a fully adjustable lush reverb, with level and decay controls. Channel two has its own input gain control and output master volume. It shares tone controls with channel one, as well as the tone controls being active with the gain boost activated.

The Full House®-50 is based on two 12AX7 preamp stages and a 12AT7 driver stage. A surprising amount of clean headroom is available before the output stage begins distorting with an American style tone, that's sweet and warm up and including clipping, and well into natural overdrive. Its tone provides a clean cutting rock edge, filled with a rich harmonics and just the right amount of chime. More clean headroom than Four Aces or Lucky-7®, but the same great tones both clean and dirty! The circuit design also is "attenuator friendly". The Full House®-50 and its siblings the Four Aces, Lucky-7®-II and Blackjack 21®-II have a preamp stage inspired by our ODS® and TDS® designs, which allow clean-to-mean from the guitar volume control on both the clean and dirty channels. What's great about this power level, is that you can use the amp as a single channel amp with reverb, gain boost, and natural amp overload, as a single channel high gain amp (using the overdrive channel and the guitar volume to control everything), or run it as a traditional channel switcher amp!

The chassis (like all Fuchs® products) is aircraft grade aluminum; our internal construction is mixed PC board and hard wired. These models have the preamp tubes and power supply circuitry are on the circuit card, while the power tubes and transformers are mounted directly on the chassis. By using single point grounding, DC filaments and regulated relay circuits, the amp is quiet and free of hum at all operating levels. A single input and 3 1/4" output jacks are provided with 4-, 8- and 16-ohm outputs. The rear panel also features an IEC power connector, fuse holder, standby switch, a patch jack for pre/post outboard effect loop, as well as a 2-way footswitch jack, which controls overdrive and gain boost.

This product hasn't received any reviews yet. Be the first to review this product!

Write your own product review